Neverox Anti-Rust Emulsion

Continuously Controls Rust Unless Mechanically or Chemically Removed

Stops Rust
Prevents Further Corrosion
Environmentally Friendly
Accepted by CFIA for use in Food Processing Establishments
Marginal Surface Preparation
Doubles as an Optimal Primer
Accepts Most Top Coats
One Shot Coating for Wrought Iron
Great for Field Repairs
Welder Friendly
VOC Compliant

5 Year Exposure to the Elements

This section of steel “I” beam pictured has been completely exposed to the weather for the past five years. It has endured rain, snow. ice and intense sunlight during that period. Temperatures during that period have ranged from --35ºC(-31ºF) to +38ºC(100ºF). The original surface was typical mill finish with rust beginning to form. A strip of Neverox was applied by brush, allowed to dry for 24 hours, and the sample was left to the elements.

The black strip of Neverox shows no sign of rust breakthrough while the unprotected balance of the surface is heavily encrusted with rust.

Neverox Anti Rust Emulsion 5 year exposure

APPLICATION PROCEDURES
Neverox® can be applied at full strength using conventional spray equipment. The product can also be applied by brush for field repair applications. A mitt can be used for application to pipe. Neverox must contact the ferrous metal surface in order to react and cure properly. Do not apply over existing coatings or paint. For new steel application, all traces of oily residues must be removed. Washing with hot water and detergent or degreasers is recommended. For rusted steel, remove loose rust, oily residues, salt or acidic deposits. Neverox® will bond well with tightly adhering rust. Tools can be cleaned with warm water and detergent.

SPECIFICATIONS

    Appearance: Dark green, viscous liquid (turns black on reaction with ferrous metal surfaces)
    Odor: Mild, slightly sweet
    pH: 4.0 @ 68ºF (20ºC)
    Solids by Volume: 66%
    Weight: 10.4 lbs. Per US gallon (3.78L)
    Chemical Resistance: Displays good resistance to mild acid and caustic solutions as well as non-aggressive oils.
    Solvent for Thinning: Water
    Coverage: 150 sq. ft. per gal. on smooth surfaces (7 mils dft)
    Flexibility: 1/8” pass (Mandrel Flex ASTM D522)
    Salt Spray Test: 500 hours (ASTM B117)
    Heat Resistance: 347ºF (175ºC) with temporary excursions to 446ºF (230ºC)
    Dry Time: Tack Free 1 hour @ 77ºF (25ºC) Hard 24 hours
    Recoat Time: After 1 hour
    Topcoating with Solvent Finishes: After 24 hours
    Application Methods: High pressure airless spray, conventional spray (thinned), brush, roller or mitt.
    Meets CFIA requirements for use in food processing plants
    Packaging: 1 US gallon, 5 US gallon pails, 55 US gallon drums

POLYCOATINGS INTERNATIONAL Windsor | Barrie | Atlanta 1-877-434-1658